Hp officejet pro 8500 paper jam
During printing, the printer stops feeding pages, and the error message 'Paper Jam. If any torn pieces of paper remain inside the product, more paper jams are likely to occur, and this might damage the print mechanism.
Thanks in advance! Replace the printer on top of Tray 2. Press in the buttons on the sides of the two-sided printing accessory duplexerand then remove the duplexer by pulling it away from the printer.
If the alignment page prints successfully, there is no need to continue troubleshooting. If any torn pieces of paper remain inside the printer, more jams are likely to occur.
Solution one: Clear the paper jam Follow these steps in the order presented to resolve the issue. Wait for the carriage to stop and become idle before you proceed.
Hp officejet pro 8600 paper jam error but no paper jam
If any torn pieces of paper remain inside the product, more paper jams are likely to occur, and this might damage the print mechanism. Without opening the cartridge access door, raise the lid of the input tray and check for jammed paper. Latch on rear of the duplexer Duplexer cover Remove any jammed paper from inside the duplexer. The label on the printhead must match the label on the printhead latch. Press in the buttons on the sides of the two-sided printing accessory duplexer , and then remove the duplexer by pulling it away from the printer. Clear jammed paper from Tray 2 Remove any loose or jammed paper that is accessible from the Tray 2 area. Only add paper to the tray when the product is not printing. Repeat these steps to remove the other printhead. Allow the rollers of the duplexer to dry for 10 or 15 minutes. Step 3: Clean the rollers Dust, paper fiber, and other debris might accumulate on the paper feed rollers and cause paper jams and paper feed issues. Figure : Lift the output tray If you see jammed paper, gently pull it out. Remove any crumpled or jammed paper from the capping station compartment 3.
Damaged or dirty paper rollers.
based on 36 review